Nobody reads anymore. But for those that do, it’s amazing what you can find out. A wealth of information awaits you below. Ok, ok, if you just want us to give you the answer, we’re happy to – just contact us.
Click on your question and the answer will be revealed
Due to the technical nature of our product, we recommend sending any watches in needs of repair or parts be sent to us to ensure proper installation. If installation of the parts required will not compromise the integrity of the case, band, or movement, please contact us and we will provide ordering instructions.
All of Reactor’s rubber straps can be ordered online by visiting the Reactor Outlet. If you have any questions about which strap to order, or you are trying to install a rubber strap on a watch not originally equipped with one, then please contact our parts dept. by calling 800-291-6600.
All of our watches come with additional links located underneath the re-sealable magnet on the bottom of the watch can. If yours are missing, or if you need additional links, contact us and more links will be sent to you free of charge. Links should be installed by your dealer or a qualified watch technician.
If your watch is set correctly, the date will change automatically starting at midnight. Follow the instructions on setting your watch found in the Care & Use manual. Please note that a complete day/date change can take up to three hours, and you will not be able to change the day or date using the crown during this period. If you are trying to set your watch for the first time and cannot get the date to move, pull the crown to the next click, advance the time past six o’clock, then press the crown back in one click. The day and/or date window should now be freed and able to move.
The reset position of the chrono sweep hand is adjustable. Simply unscrew the crown and pull it all the way out as if to change the time. Then click the top start/stop button to advance the hand in one second intervals until it is set to your desired position. Make sure to screw the crown down tightly when finished.
While every watch leaves our factory with a fresh battery, it is impossible for us to control how long the watch may have been in your dealer’s inventory. Unlike most watch companies, Reactor’s warranty covers the battery. Visit our Repair Service page for instructions on returning your watch to us. We’ll install a fresh battery, pressure test, and polish your watch and have it on it’s way back to you in 48 hours at no charge.
While this problem is unusual, it can be caused by several factors. Most commonly, the watch has been immersed with the crown partially unscrewed, allowing a tiny amount of moisture past the seal. While Reactors are the only watches to have a screw-down crown that is water tight when unscrewed, it is good practice to check that the crown is tight before submerging the watch. In extreme cold conditions, the condensation may be caused by the humidity of the air inside the watch from when it was assembled or serviced. In most cases, simply warming the watch, such as by holding close to a light bulb for a few minutes, will correct the problem. Severe or more persistent fogging may indicate a more serious issue. In this case, the watch should be returned to us following the instructions on our Repair Service page.
Copyright 2017 by Reactor Watch, LP. All rights reserved | ReactorWatch.com Was Optimized for Performance by WpFASTER.
Use this form to find things you need on this site